Welcome to The Launceston Timber Co Ltd

Thank you for taking the time to visit our website. We take great pride in our products and make them to perfection first time, and every time.

We hope you find what you are looking for, but be rest assured, if you cannot find a specific item then please feel free to email or call us as we specialise in bespoke and custom-made products.

For measurement purposes and accuracy, all metal and joinery items are manufactured by us, and are always viewed from the outside of the building looking at it. Also known as the aperture.

Inverse Bow Top With Center Bars & Balls Metal Side Gate (MPG10)

Made to Measure - Heavy Duty

Sizes

Select as required.

For custom sizes to the mm at no extra cost, select the closest size above and email us your exact width and height.

Material

STEEL FRAMES 40mm X 40mm BOX

STEEL CENTER BARS 12.5MM 

Configuration

Side hung

Gate sections

40mm thick

Styles 40mm face

Joints - flat welded

Finish

(Finished as standard)

Metal fully finished in gloss black.

Available Sizes:

• Width: from 2ft to 6ft 
• Height: from 4ft to 7ft – taken to the highest point of the gate.
• Made to Measure – all gates online can be purchased to the nearest inch. If you do require a more precise size, please contact us. (Unlike others – there is NO additional cost for bespoke, we simply base price on the next size up that’s needed!).

Gate Furniture:

• Included FREE of charge: 2 x Adjustable hinges (and hinge pins), stainless steel handle and lock providing ultimate protection for your home. 1 x drop bolts. As standard, the position of the hinge pin will be 6″ (150mm) from top and bottom of the gate. If you require these at a different measurement (for example, pins already set in pillars), please call to order.

Finish:

• As standard, the framework will be finished in black
• Anthracite grey or white (additional extra in price)
• We can also supply the frame in any RAL colour if needed

Posts:

• Due to the weight of these gates, we only recommend “below ground” posts for support, or to install to existing pillars (as long as the pillar is structurally sound).

How to calculate

Calculating gate width with existing pillars or posts in place.

Take THREE measurements between the pillars/posts. Across the top, middle and the bottom. Make a note of the SMALLEST measurement.

To determine what clearance is needed to calculate gate width, you must decide how the gate will open. The first example is by far the most popular set up.

FIGURE 1: (most popular set up)

Gates to open towards the driveway. Hinge plates mounted to the rear face of the post/pillar. Back edge of the gate sits flush with the back edge of the post/ pillar.

REDUCE 50mm (2″) from your lowest measurement.

FIGURE 2:

Driveway gates can open inwards towards the driveway or out towards the road. Please note, if swinging out towards the road, the gate cannot cross a public footpath/highway. Hinge plates mounted to the inside face of the post/pillar. Front edge of the gate sits flush with the front edge of the post/pillar.

REDUCE 150mm (6″) from your lowest measurement.

Any general builder or joiner will be able to install these, but we can help over the phone with installation/advise if needed.

We would advise 1 day installation time with 2 people (recommendation only).

We do offer an installation service, please contact us for prices if you require this.

Lead time

Please check our current delivery lead times pre order, as all items are made to order.

Some sections are very heavy, so lifting equipment maybe/will be required.

These are made and machined from start to finish by ourselves, and we take great pride in doing so.
Buying direct from the sawmill/ manufacturers, means you can make great savings.